IndiaBIX
IndiaBIX
Start typing & press "Enter" or "ESC" to close
  • Home
  • Jobs
  • Results
  • Current Affairs
  • GK
  • Online Test
  • HR Interview
  • BLOG

Networking - Section 1 (4)

  • Home
  • Computer Science & Engineering
  • Computer Science Questions and Answers
  • Networking - Section 1
25. 

ICMP (Internet Control Message Protocol) is

A. a TCP/IP protocol used to dynamically bind a high level IP Address to a low-level physical hardware address
B. a TCP/IP high level protocol for transferring files from one machine to another
C. a protocol used to monitor computers
D. a protocol that handles error and control messages
E. None of the above

Answer: Option D

Explanation:

No answer description available for this question. Let us discuss.

View Answer Discuss Workspace Report

26. 

A remote batch-processing operation in which data is solely input to a central computer would require a:

A. telegraph line
B. simplex lines
C. mixedband channel
D. All the above
E. None of the above

Answer: Option B

Explanation:

No answer description available for this question. Let us discuss.

View Answer Discuss Workspace Report

27. 

Which of the following TCP/IP protocol allows an application program on one machine to send a datagram to an application program on another machine?

A. UDP
B. VMTP
C. X.25
D. SMTP
E. None of the above

Answer: Option A

Explanation:

No answer description available for this question. Let us discuss.

View Answer Discuss Workspace Report

28. 

A distributed network configuration in which all data/information pass through a central computer is

A. bus network
B. star network
C. ring network
D. Point-to-point network
E. None of the above

Answer: Option B

Explanation:

No answer description available for this question. Let us discuss.

View Answer Discuss Workspace Report

29. 

The synchronous modems are more costly than the asynchronous modems becauseThe synchronous modems are more costly than the asynchronous modems because

A. they produce large volume of data
B. they contain clock recovery circuits
C. they transmit the data with stop and start bits.
D. they operate with a larger bandwidth
E. None of the above

Answer: Option B

Explanation:

No answer description available for this question. Let us discuss.

View Answer Discuss Workspace Report

30. 

Which of the following device is used to connect two systems, especially if the systems use different protocols?

A. hub
B. bridge
C. gateway
D. repeater
E. None of the above

Answer: Option C

Explanation:

No answer description available for this question. Let us discuss.

View Answer Discuss Workspace Report

31. 

Which of the following TCP/IP protocol is used for transferring electronic mail messages from one machine to another?

A. FTP
B. SNMP
C. SMTP
D. RPC
E. None of the above

Answer: Option C

Explanation:

No answer description available for this question. Let us discuss.

View Answer Discuss Workspace Report

32. 

When you ping the loopback address, a packet is sent where?

A. On the network
B. Down through the layers of the IP architecture and then up the layers again
C. Across the wire
D. through the loopback dongle
E. None of the above

Answer: Option B

Explanation:

No answer description available for this question. Let us discuss.

View Answer Discuss Workspace Report

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7

Questions & Answers

Aptitude Chemical Engineering Civil Engineering Computer Science & Engineering Current Affairs Data Interpretation Electrical & Electronics Engineering Electronics & Communication Engineering General Knowledge Logical Reasoning Mechanical Engineering Non Verbal Reasoning Verbal Ability Verbal Reasoning

Interviews

HR Interview

Jobs

Sarkari Jobs

Results

Rojgar ResultSarkari Result

Admission

Admission 2023

Admit Card

Admit Card 2023

Answer Key

Answer Key 2023
copyright
Privacy Policy
© 2025 IndiaBIX. All Rights Reserved.

Report