When a router is connected to a Frame Relay WAN link using a serial DTE interface, how is the clock rate determined?
| 1. | When a router is connected to a Frame Relay WAN link using a serial DTE interface, how is the clock rate determined? |
|||||||
Answer: Option A Explanation: Clocking on a serial interface is always provided by the CSU/DSU (DCE device). However, if you do not have a CSU/DSU in your nonproduction test environment, then you need to supply clocking with the clock rate command on the serial interface of the router with the DCE cable attached. |
Leave a Comment
Computer Science & Engineering :: Networking Questions and Answers : More Exercises
- Networking Basics - Networking Basics
- TCP/IP - TCP/IP
- IOS and Security Device Manager - IOS and Security Device Manager
- IP Routing - IP Routing
- Spanning Tree Protocol - Spanning Tree Protocol
- Security - Security
- Wireless Technologies - Wireless Technologies
- Wide Area Networks - Wide Area Networks
- Internetworking - Internetworking
- Subnetting - Subnetting
- Managing a Cisco Internetwork - Managing a Cisco Internetwork
- EIGRP and OSPF - EIGRP and OSPF
- Virtual LANs - Virtual LANs
- Network Address Translation - Network Address Translation
- IPv6 - IPv6