You need to configure a router for a Frame Relay connection to a non-Cisco router. Which of the following commands will prepare the WAN interface of the router for this connection?
| 1. | You need to configure a router for a Frame Relay connection to a non-Cisco router. Which of the following commands will prepare the WAN interface of the router for this connection? |
|||||||
Answer: Option C Explanation: If you have a Cisco router on one side of a Frame Relay network and a non-Cisco router on the other side, you would need to use the Frame Relay encapsulation type of IETF. The default is Cisco encapsulation, which means that a Cisco router must be on both sides of the Frame Relay network. |
Leave a Comment
Computer Science & Engineering :: Networking Questions and Answers : More Exercises
- Networking Basics - Networking Basics
- TCP/IP - TCP/IP
- IOS and Security Device Manager - IOS and Security Device Manager
- IP Routing - IP Routing
- Spanning Tree Protocol - Spanning Tree Protocol
- Security - Security
- Wireless Technologies - Wireless Technologies
- Wide Area Networks - Wide Area Networks
- Internetworking - Internetworking
- Subnetting - Subnetting
- Managing a Cisco Internetwork - Managing a Cisco Internetwork
- EIGRP and OSPF - EIGRP and OSPF
- Virtual LANs - Virtual LANs
- Network Address Translation - Network Address Translation
- IPv6 - IPv6