You copy a configuration from a network host to a router's RAM. The configuration looks correct, yet it is not working at all. What could the problem be?

[A].	You copied the wrong configuration into RAM.
[B].	You copied the configuration into flash memory instead.
[C].	The copy did not override the shutdown command in running-config.
[D].	The IOS became corrupted after the copy command was initiated.

Answer: Option C

Explanation:

Since the configuration looks correct, you probably didn't screw up the copy job. However, when you perform a copy from a network host to a router, the interfaces are automatically shut down and need to be manually enabled with the no shutdown command.

Computer Science & Engineering :: Networking Questions and Answers : More Exercises

Networking Basics - Networking Basics
TCP/IP - TCP/IP
IOS and Security Device Manager - IOS and Security Device Manager
IP Routing - IP Routing
Spanning Tree Protocol - Spanning Tree Protocol
Security - Security
Wireless Technologies - Wireless Technologies
Wide Area Networks - Wide Area Networks
Internetworking - Internetworking
Subnetting - Subnetting
Managing a Cisco Internetwork - Managing a Cisco Internetwork
EIGRP and OSPF - EIGRP and OSPF
Virtual LANs - Virtual LANs
Network Address Translation - Network Address Translation
IPv6 - IPv6

You copy a configuration from a network host to a router's RAM. The configuration looks correct, yet it is not working at all. What could the problem be?

Computer Science & Engineering :: Networking Questions and Answers : More Exercises

Questions & Answers

Interviews

Jobs

Results

Admission

Admit Card

Answer Key