To enable EIGRP, which of the following would you use? 1 Router1(config-if)# ipv6 ospf 10 area 0.0.0.0 2 Router1(config-if)# ipv6 router rip 1 3 Router1(config)# ipv6 router eigrp 10 4 Router1(config-rtr)# no shutdown 5 Router1(config-if)# ipv
| 1. | To enable EIGRP, which of the following would you use?
|
|||||||
Answer: Option B Explanation: Unlike RIPng and OSPFv3, you need to configure EIGRP both from global configuration mode and from interface mode, and you have to enable the command with the no shutdown command. |
Leave a Comment
Computer Science & Engineering :: Networking Questions and Answers : More Exercises
- Networking Basics - Networking Basics
- TCP/IP - TCP/IP
- IOS and Security Device Manager - IOS and Security Device Manager
- IP Routing - IP Routing
- Spanning Tree Protocol - Spanning Tree Protocol
- Security - Security
- Wireless Technologies - Wireless Technologies
- Wide Area Networks - Wide Area Networks
- Internetworking - Internetworking
- Subnetting - Subnetting
- Managing a Cisco Internetwork - Managing a Cisco Internetwork
- EIGRP and OSPF - EIGRP and OSPF
- Virtual LANs - Virtual LANs
- Network Address Translation - Network Address Translation
- IPv6 - IPv6