Auxiliary Views - General Questions (2)

Directions to Solve

Auxiliary Views - General Questions

9.

This is the most common application for developments and intersections:

A.	Sheet metal construction
B.	Piping
C.	Architecture
D.	Mechanical engineering

Answer: Option A

Explanation:

No answer description available for this question. Let us discuss.

10.

When using the descriptive geometry method to create an auxiliary view the drafter should ________.

A.	rotate the snap grid to the same angle of the inclined plane
B.	offset the right vertical line of the front view
C.	rotate the top line of the front view 45 degrees
D.	offset the top line of the front view 2 inches

Answer: Option A

Explanation:

No answer description available for this question. Let us discuss.

11.

In this type of auxiliary view, a break line is used to indicate the imaginary break in the views:

A.	Primary
B.	Secondary
C.	Revolved
D.	Partial

Answer: Option D

Explanation:

No answer description available for this question. Let us discuss.

12.

An efficient method for trimming the corners on an auxiliary view is to use the ________.

A.	0 radius fillet
B.	Hatch tool
C.	Extend tool
D.	Grips function

Answer: Option A

Explanation:

No answer description available for this question. Let us discuss.

13.

When adding dimensions to an auxiliary view it will be necessary to use the ________ tool.

A.	Linear dimension
B.	Aligned dimension
C.	Baseline dimension
D.	Angle dimension

Answer: Option B

Explanation:

No answer description available for this question. Let us discuss.

14.

Circular shapes appear in this fashion when viewed at an angle other than 90 degrees:

A.	Circular
B.	Elliptical
C.	Lengthened
D.	Angular

Answer: Option B

Explanation:

No answer description available for this question. Let us discuss.

15.

The principle reason for using an auxiliary view is ________.

A.	to eliminate hidden lines
B.	to create a true projection plane from an inclined plane in one of the primary views
C.	to show cylinders as ellipses
D.	to locate center marks

Answer: Option B

Explanation:

No answer description available for this question. Let us discuss.

16.

The offset distance for the width (front to back) distance of the auxiliary view is the same distance of the ________ in the top view.

A.	Width
B.	height
C.	length
D.	none of the above

Answer: Option A

Explanation:

No answer description available for this question. Let us discuss.

1
2
3