IndiaBIX
IndiaBIX
Start typing & press "Enter" or "ESC" to close
  • Home
  • Jobs
  • Results
  • Current Affairs
  • GK
  • Online Test
  • HR Interview
  • BLOG

Workshop Technology - Section 1 (3)

  • Home
  • Mechanical Engineering
  • Mechanical Engineering Q&A
  • Workshop Technology - Section 1
Directions to Solve

Workshop Technology - Section 1

17. 

The cross-section of a chisel is usually

A. rectangular
B. square
C. hexagonal
D. octagonal

Answer: Option D

Explanation:

No answer description available for this question.

View Answer Discuss Workspace Report

18. 

The blank diameter used in thread rolling will be

A. equal to minor diameter of the thread
B. equal to pitch diameter of the thread
C. a little larger than the minor diameter of the thread
D. a little larger than the pitch diameter of the thread

Answer: Option C

Explanation:

No answer description available for this question.

View Answer Discuss Workspace Report

19. 

The purpose of a riser is to

A. deliver molten metal into the mould cavity
B. act as a reservoir for the molten metal
C. feed the molten metal to the casting in order to compensate for the shrinkage
D. deliver the molten metal from pouring basin to gate

Answer: Option C

Explanation:

No answer description available for this question.

View Answer Discuss Workspace Report

20. 

In average work, the tolerance produced by investment casting method is

A. ±0.05 mm
B. +0.2 mm
C. +05 mm
D. +1 mm

Answer: Option A

Explanation:

No answer description available for this question.

View Answer Discuss Workspace Report

21. 

The bloom is smaller than a billet.

A. True
B. False

Answer: Option B

Explanation:

No answer description available for this question.

View Answer Discuss Workspace Report

22. 

When a hole or cavity to be cored is not in line with the parting surface, then a __________ is used.

A. horizontal core
B. vertical core
C. drop core
D. balanced core

Answer: Option C

Explanation:

No answer description available for this question.

View Answer Discuss Workspace Report

23. 

The instrument which has all the features of try-square, bevel protractor, rule and scriber, is

A. outside micrometer
B. inside micrometer
C. depth gauge micrometer
D. combination set

Answer: Option D

Explanation:

No answer description available for this question.

View Answer Discuss Workspace Report

24. 

Metal patterns are used for

A. small castings
B. large castings
C. complicated castings
D. large scale production of castings

Answer: Option D

Explanation:

No answer description available for this question.

View Answer Discuss Workspace Report

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7

Questions & Answers

Aptitude Chemical Engineering Civil Engineering Computer Science & Engineering Current Affairs Data Interpretation Electrical & Electronics Engineering Electronics & Communication Engineering General Knowledge Logical Reasoning Mechanical Engineering Non Verbal Reasoning Verbal Ability Verbal Reasoning

Interviews

HR Interview

Jobs

Sarkari Jobs

Results

Rojgar ResultSarkari Result

Admission

Admission 2023

Admit Card

Admit Card 2023

Answer Key

Answer Key 2023
copyright
Privacy Policy
© 2025 IndiaBIX. All Rights Reserved.

Report