IndiaBIX
IndiaBIX
Start typing & press "Enter" or "ESC" to close
  • Home
  • Jobs
  • Results
  • Current Affairs
  • GK
  • Online Test
  • HR Interview
  • BLOG

Theory of machines - Section 1

  • Home
  • Mechanical Engineering
  • Mechanical Engineering Q&A
  • Theory of machines - Section 1
Directions to Solve

Theory of machines - Section 1

1. 

The cam follower generally used in automobile engines is

A. knife edge follower
B. fiat faced follower
C. spherical faced follower
D. roller follower

Answer: Option C

Explanation:

No answer description available for this question.

View Answer Discuss Workspace Report

2. 

A mass of 1 kg is attached to the end of a spring with a stiffness of 0.7 N/mm. The critical damping coefficient of this system is

A. 1.4 N-s/m
B. 18.52 N-s/m
C. 52.92 N-s/m
D. 529.2 N-s/m

Answer: Option C

Explanation:

No answer description available for this question.

View Answer Discuss Workspace Report

3. 

The gear train usually employed in clocks is a

A. simple gear train
B. reverted gear train
C. sun and planet gear
D. differential gear

Answer: Option B

Explanation:

No answer description available for this question.

View Answer Discuss Workspace Report

4. 

In order to give the primary balance of the reciprocating parts of a multi-cylinder in-line engines,

A. the algebraic sum of the primary forces must be equal to zero
B. the algebraic sum of the couples about any point in the plane of the primary forces must be equal to zero
C. both (a) and (b)
D. none of these

Answer: Option C

Explanation:

No answer description available for this question.

View Answer Discuss Workspace Report

5. 

The frictional torque transmitted in a multi-collared shaft is same as that of a single collared shaft.

A. Right
B. Wrong

Answer: Option A

Explanation:

No answer description available for this question.

View Answer Discuss Workspace Report

6. 

An automobile steering gear is an example of

A. sliding pair
B. rolling pair
C. lower pair
D. higher pair

Answer: Option C

Explanation:

No answer description available for this question.

View Answer Discuss Workspace Report

7. 

In a screw jack, the effort required to lower the load W is given by

A. P = W tan(α - φ)
B. P = W tan(α + φ)
C. P = W tan(φ - α)
D. P = W cos(α + φ)

Answer: Option C

Explanation:

No answer description available for this question.

View Answer Discuss Workspace Report

8. 

In order to balance the reciprocating masses,

A. primary forces and couples must be balanced
B. secondary forces and couples must be balanced
C. both (a) and (b)
D. none of these

Answer: Option C

Explanation:

No answer description available for this question.

View Answer Discuss Workspace Report

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7

Questions & Answers

Aptitude Chemical Engineering Civil Engineering Computer Science & Engineering Current Affairs Data Interpretation Electrical & Electronics Engineering Electronics & Communication Engineering General Knowledge Logical Reasoning Mechanical Engineering Non Verbal Reasoning Verbal Ability Verbal Reasoning

Interviews

HR Interview

Jobs

Sarkari Jobs

Results

Rojgar ResultSarkari Result

Admission

Admission 2023

Admit Card

Admit Card 2023

Answer Key

Answer Key 2023
copyright
Privacy Policy
© 2025 IndiaBIX. All Rights Reserved.

Report