Radio Receivers - Section 1 (5)

Directions to Solve

Radio Receivers - Section 1

33. 

Standard AM radio broadcasts are confined to
A. MF
B. HF
C. VHF
D. UHF

Answer: Option A

Explanation:

No answer description available for this question. Let us discuss.

View Answer Discuss Workspace Report
34. 

Transistor are free from which type of noise?
A. Resistance noise
B. Partition noise
C. Flicker noise
D. Shot noise

Answer: Option B

Explanation:

No answer description available for this question. Let us discuss.

View Answer Discuss Workspace Report
35. 

In a receiver, which of the following device has IF input but RF output?
A. Demodulator
B. Loudspeaker
C. Audio amplifier
D. Frequency changer

Answer: Option A

Explanation:

No answer description available for this question. Let us discuss.

View Answer Discuss Workspace Report
36. 

It is known that noise phase modulates the FM wave. As the noise side band frequency approaches the carrier frequency, the noise amplitude
A. will increase
B. will decrease
C. will remain constant
D. will reduce to negligible value

Answer: Option B

Explanation:

No answer description available for this question. Let us discuss.

View Answer Discuss Workspace Report
37. 

When fs is the signal frequency and fi is the intermediate frequency, then image frequency fsi is given by
A. fsi = fs - 2fi
B. fsi = fs + 2fi
C. 06-35-3
D. 06-35-4

Answer: Option B

Explanation:

No answer description available for this question. Let us discuss.

View Answer Discuss Workspace Report
38. 

Neutralization is used in RF amplifiers to
A. stop oscillation
B. increase bandwidth
C. improve selectivity
D. all of the above

Answer: Option A

Explanation:

No answer description available for this question. Let us discuss.

View Answer Discuss Workspace Report
39. 

In a ratio detector
A. the linearity is worse than in a phase discriminator
B. the output is twice that obtainable from a similar phase discriminator
C. stabilization against signal strength variations is provided
D. the circuit is the same as in a discriminator, except that the diodes are reversed

Answer: Option A

Explanation:

No answer description available for this question. Let us discuss.

View Answer Discuss Workspace Report
40. 

Which are the popular IF frequencies for microwave and radar receivers operating on frequencies in the range 1 to 10 GHz
A. 30, 60 and 70 kHz
B. 3, 6 and 7 kHz
C. 30, 60 and 70 MHz
D. 3, 6 and 7 GHz

Answer: Option C

Explanation:

No answer description available for this question. Let us discuss.

View Answer Discuss Workspace Report

Questions & Answers

Aptitude Chemical Engineering Civil Engineering Computer Science & Engineering Current Affairs Data Interpretation Electrical & Electronics Engineering Electronics & Communication Engineering General Knowledge Logical Reasoning Mechanical Engineering Non Verbal Reasoning Verbal Ability Verbal Reasoning

Interviews

HR Interview

Jobs

Sarkari Jobs

Results

Rojgar ResultSarkari Result

Admission

Admission 2023

Admit Card

Admit Card 2023

Answer Key

Answer Key 2023