IndiaBIX
IndiaBIX
Start typing & press "Enter" or "ESC" to close
  • Home
  • Jobs
  • Results
  • Current Affairs
  • GK
  • Online Test
  • HR Interview
  • BLOG

Alternating Current and Voltage - General Questions (3)

  • Home
  • Electrical & Electronics Engineering
  • Electrical Engineering Questions and Answers
  • Alternating Current and Voltage - General Question
Directions to Solve

Alternating Current and Voltage - General Questions

17. 

If the peak of a sine wave is 13 V, the peak-to-peak value is

A. 6.5 V
B. 13 V
C. 26 V
D. none of the above

Answer: Option C

Explanation:

No answer description available for this question.
View Answer Discuss Workspace Report

18. 

 

A 20 kHz pulse waveform consists of pulses that are 15 s wide. The duty cycle

A. is 1%
B. is 30%
C. is 100%
D. cannot be determined

Answer: Option B

Explanation:

No answer description available for this question.
View Answer Discuss Workspace Report

19. 

A pulse waveform has a high time of 8 ms and a pulse width of 32 ms. The duty cycle is

A. 25%
B. 50%
C. 1%
D. 100%

Answer: Option A

Explanation:

No answer description available for this question.
View Answer Discuss Workspace Report

20. 

If the rms current through a 4.7 k resistor is 4 mA, the peak voltage drop across the resistor is

A. 4 V
B. 18.8 V
C. 26.6 V
D. 2.66 V

Answer: Option C

Explanation:

No answer description available for this question.
View Answer Discuss Workspace Report

21. 

One sine wave has a positive-going zero crossing at 15° and another sine wave has a positive-going zero crossing at 55°. The phase angle between the two waveforms is

A. 0°
B. 45°
C. 40°
D. none of the above

Answer: Option C

Explanation:

No answer description available for this question.
View Answer Discuss Workspace Report

22. 

To produce an 800 Hz sine wave, a four-pole generator must be operated at

A. 200 rps
B. 400 rps
C. 800 rps
D. 1,600 rps

Answer: Option B

Explanation:

No answer description available for this question.
View Answer Discuss Workspace Report

23. 

 

How many degrees are there in /3 rad?

A. 6°
B. 60°
C. 180°
D. 27°

Answer: Option B

Explanation:

No answer description available for this question.
View Answer Discuss Workspace Report

24. 

The conductive loop on the rotor of a simple two-pole, single-phase generator rotates at a rate of 400 rps. The frequency of the induced output voltage is

A. 40 Hz
B. 100 Hz
C. 400 Hz
D. indeterminable

Answer: Option C

Explanation:

No answer description available for this question.
View Answer Discuss Workspace Report

  • 1
  • 2
  • 3
  • 4

Questions & Answers

Aptitude Chemical Engineering Civil Engineering Computer Science & Engineering Current Affairs Data Interpretation Electrical & Electronics Engineering Electronics & Communication Engineering General Knowledge Logical Reasoning Mechanical Engineering Non Verbal Reasoning Verbal Ability Verbal Reasoning

Interviews

HR Interview

Jobs

Sarkari Jobs

Results

Rojgar ResultSarkari Result

Admission

Admission 2023

Admit Card

Admit Card 2023

Answer Key

Answer Key 2023
copyright
Privacy Policy
© 2025 IndiaBIX. All Rights Reserved.

Report