Furnace Technology - Section 1 (2)
- Home
- Chemical Engineering
- Chemical Engineering Questions and Answers
- Furnace Technology - Section 1
Furnace Technology - Section 1
If you are looking for MCQs and other problems based on Furnace
technology then you are at right place, you can find these problems in the following section.
| 9. | Coke ovens in steel plant are heated by |
|||||||
Answer: Option D Explanation: No answer description available for this question. Let us discuss. |
| 10. | Heat transfer rate to the stock/charge in the furnace does not depend upon the |
|||||||
Answer: Option C Explanation: No answer description available for this question. Let us discuss. |
| 11. | Thermal efficiency of blast furnace stoves used for heating blast (air) may be about __________ percent. |
|||||||
Answer: Option D Explanation: No answer description available for this question. Let us discuss. |
| 12. | Low stack loss indicates the |
|||||||
Answer: Option B Explanation: No answer description available for this question. Let us discuss. |
| 13. | Acid dew point temperature (ADT) of a flue gas produced by the combustion of a fuel containing 1% sulphur may be about __________ °C. |
|||||||
Answer: Option B Explanation: No answer description available for this question. Let us discuss. |
| 14. | Which of the following is not an additive for flue gases from furnace to reduce its dew-point? |
|||||||
Answer: Option D Explanation: No answer description available for this question. Let us discuss. |
| 15. | The reason for excessive clinker formation in gas producers is the |
|||||||
Answer: Option D Explanation: No answer description available for this question. Let us discuss. |
| 16. | Which of the following is not a directly fired furnace ? |
|||||||
Answer: Option A Explanation: No answer description available for this question. Let us discuss. |