Dimensioning - General Questions

In U.S. structural and architectural drafting, all dimensions of this length are usually expressed in feet and inches:

This is a line terminated by arrowheads, indicating the direction and extent of a dimension:

The maximum and minimum sizes of a feature are identified by a ________ tolerance.

This is a thin solid line directing attention to a note or dimension and starting with an arrowhead or dot:

Given a situation in which the drafter has crossed extension lines in a drawing what can be done to clean up the point of crossing?

Baseline dimensions are referenced from a common geometric feature known as a ________.

Placement of dimensions on a drawing is controlled by ________.

The ________ dimension tool will place the length of an angled line.