Production Engineering - Section 1

Directions to Solve

Production Engineering - Section 1

1.

Grinding wheels should be tested for balance

A.	only at the time of manufacture
B.	before starting the grinding operation
C.	at the end of grinding operation
D.	occasionally

Answer: Option D

Explanation:

No answer description available for this question. Let us discuss.

2.

In ultra-sonic machining, the metal is removed by

A.	using abrasive slurry between the tool and work
B.	direct contact of tool with the work
C.	maintaining an electrolyte between the work and tool in a very small gap between the two
D.	erosion caused by rapidly recurring spark discharges between the tool and work

Answer: Option A

Explanation:

No answer description available for this question. Let us discuss.

3.

In hot machining, tool is made of

A.	tungsten carbide
B.	brass or copper
C.	diamond
D.	stainless steel

Answer: Option A

Explanation:

No answer description available for this question. Let us discuss.

4.

The angle included between the two lips projected upon a plane parallel to the drill axis and paralled to the two cutting lips, is called helix angle.

A.	Correct
B.	Incorrect

Answer: Option B

Explanation:

No answer description available for this question. Let us discuss.

5.

If the helix angle of the drill is made __________ 30°, then the torque required to drive the drill at a given feed will be more.

A.	equal to
B.	less than
C.	more than

Answer: Option B

Explanation:

No answer description available for this question. Let us discuss.

6.

The different spindle speeds on a lathe form

A.	arithmetical progression
B.	geometrical progression
C.	harmonical progression
D.	any one of these

Answer: Option B

Explanation:

No answer description available for this question. Let us discuss.

7.

Lapping is an operation of

A.	making a cone-shaped enlargement of the end of a hole
B.	smoothing and squaring the surface around a hole
C.	sizing and finishing a small diameter hole
D.	producing a hole by removing metal along the circumference of a hollow cutting tool

Answer: Option C

Explanation:

No answer description available for this question. Let us discuss.

8.

In orthogonal cutting system, the maximum chip thickness occurs at the middle.

A.	Correct
B.	Incorrect

Answer: Option A

Explanation:

No answer description available for this question. Let us discuss.

1
2
3
4
5
6
7